Remote Control - Avol itrio User Manual

Operation Control & Function

Remote control

■
Description
To turn on/off the power of transmitter and receiver.
Power on :
○
- If you turn on TX or RX when power/Link LED is on , both devices will be power-on simultaneously within 10 seconds.
- You have to turn on each of TX and RX separately when power/Link LED is off, it may takes around 1 min 30 seconds for booting up.
1 POWER
Power off (press shortly) : When you turn off TX or RX, both devices will be power-off simultaneously and only power LED will be on.
○
Power off (press more than 4 sec) : When you turn off TX or RX, both devices will be power-off simultaneously, and LED will be off.
○
Power will be completely turned off.
Note1. If the power is off abnormally, the user's configuration may not be saved.
Display the current resolution, input / output ports, channel, WiFi reception (1/5~5/5). (5/5 strongest, 1/5 weakest)
2 INFO
It appears when you press and disappears automatically after around 20 seconds.
3 VIDEO OUT Select VIDEO output port of the receiver (HDMI, COMPO , AV)
4 VIDEO IN
Select VIDEO input port on the transmitter (HDMI1, HDMI2, PC, AV)
Select AUDIO input port on the transmitter (HDMI1, HDMI2, PC, AV)
5 AUDIO IN
Audio port is selected same with video port as a default. But you can select particular audio port using this button.
6 LAN(Red) Select LAN (Cable) mode.
7 WiFi Ch1(Green) Select WiFi (Wireless) mode, Ch1.
8 WiFi Ch2(Yellow)
Select WiFi (Wireless) mode, Ch2.
⑥~⑧ are functioned HD-W100 model only.
Note 1.
⑥~⑧ are applied only when you press the button more than 5 seconds. On the normal link stage, if you change either TX or RX both device
Note 2.
will be changed simultaneously.
Otherwise you should change on TX and RX separately. (Info screen appears on the display for 3 seconds if it changes appropriately.
It will be rebooting when you change for ⑥~⑧ . Power/Link LED will blink in a short time and reboot.
Note 3.
Link may be interfered caused by wrong setting or malfunction of ⑥~⑧ button. In this case, please select desired communication mode
Note 4.
(LAN/WiFi) or channel to each transmitter and receiver using remote control.
* TX : Transmitter, RX : Receiver
10
1
4
3
6
7
Function
2
5
8