Audio Format Supported; Change Wifi Frequency; Factory Reset - Avol itrio User Manual

Product Specification

Audio Format Supported

■
1)
Digital Audio
- Digital compressed audio : AC-3 Dolby Digital, DTS ( Pass Through)
2)
Analog audio
- 16bit 2-channel linear PCM (44.1kHz & 48kHz)

Change WiFi Frequency

■
1) If there are the devices that use same WiFi frequency, the receiver's output video may be
distorted because of frequency interference. In this case, you can change WiFi frequency in
order to avoid interference.
If you press the button (WiFi Ch1 / WiFi Ch2) of the remote control over 5 seconds, WiFi
2)
frequency will be changed and system will be rebooted.
3) If the transmitter and the receiver are linked appropriately, it is fine to change WiFi frequency
on the one device. However, if the transmitter and the receiver are not linked, WiFi frequency
should be changed on each of transmitter and receiver respectively.
WiFi Channel
Ch 1
Ch 2
Note1. This Function is applied to only wireless model(w).

Factory Reset

■
1) With pressing the power button of the transmitter or the receiver, connect the power.
2) Once you press the power button for 3 seconds, all the LED will blink and the system setting is set
to be factory mode.
20
Frequency Use Remote Control Button
5.19 GHz(WiFi Ch38)
5.23 GHz(WiFi Ch46)
WiFi Ch1 (Green)
WiFi Ch2 (Yellow)