Q & A - Avol itrio User Manual

Q & A
Q & A
■
1) Q : Power/Link LED keeps blinking and the transmitter and receiver are not linked
appropriately.
A : Communication method (LAN/WiFi) or channel may not be set appropriately. Please
set the desired communication method and channel by referring 4-5). ⑥~⑧.
Especially, when the system is wireless mode, make the transmitter and the receiver
closer, please check if the link is completed pressing Ch1 and ch2 for over 5 seconds
and, then, make them locate near TV. If link is established appropriately when they
are close but LED is blinking when they are apart, it means wireless signal is weakened
by some reason or it may be interfered by a wireless device which use the same
frequency in the near place.
2) Q : When itrio is turned on first time, TV screen doesn't show clearly and after a while turn
into clear picture. Is it broken?
A : It is not a broken product. When the receiver receives the video data, there is noise on
screen if the receiver couldn't receive the essential information. The screen will be
shown clearly soon.
3)
Q : Is it possible to use video output from HDMI splitter?
A : Yes, it is. However, low quality HDMI splitter may convey the video signal information
inappropriately or the electric feature of HDMI video signal form the HDMI splitter may
not satisfy the standard. Please use it carefully.
For the further information, please refer to our web page 'www.i-trio.com'
22