Miele PT 8807 Operating Instructions Manual page 13

Load weight
You can enter the weight of the load manually before
the start of the programme.
2 Cottons dry
0 % Drying
Cooling down
^ Turn the rotary dial to highlight the load. Press the
dial to confirm your selection. Turn the dial to alter
the weight and confirm your selection by pressing
it.
Temperature in 1 °C increments from cold, 30 to
max. 80 °C .
^ Turn the rotary dial to select the "Temperature" field
(70 °C for drying) and press it to confirm your
selection.
2 Cottons dry
0 % Drying
Cooling down
^ Turn the rotary dial to alter the temperature value
and then press it to confirm your selection.
Residual moisture in
1 % increments from -4 to 40 % .
^ Turn the rotary dial to select the "Residual moisture"
field (0 %) and press it to confirm your selection.
2 Cottons dry
0 % Drying
Cooling down
^ Turn the rotary dial to alter the residual moisture
level and then press it to confirm your selection.
^ Press the Start button and the programme selected
will commence
Once a programme has started the programme
sequence will appear in the display.
2 Cottons dry
0 % Drying
Cooling down
In the 2nd line of the display, drying in this example,
the actual residual moisture level (>40%) will also be
shown. The 3rd line displays the following
programme block.
The time that the programme will finish (12:35) is
shown on the right hand side of the display.
10,0 13.0 kg
70°C
e
A
m
13.0 kg
70°C
e
A
m
13.0 kg
70°C
A
m
>40 %
Ready at 12:35
m K f
The programme end display has a self-learning
function and will not show an accurate reading until
the programme has been run several times.
At the end of a programme
2 Cottons dry
Programme finished
Anti-crease
m
The programme end time is displayed,the buzzer
sounds and the anti-crease phase commences. The
drum will rotate at intervals to keep the laundry from
creasing.
This is useful if laundry is not going to be unloaded as
soon as the programme finishes.
^ Open the drum door.
^ Unload the drum.
Make sure nothing is left behind in the drum. If
items are left in the dryer, they could be damaged
by overdrying when the dryer is next used.
,
Do not unload laundry from the drum until after
the cooling down phase has been completed.
Hot laundry can self-ignite and cause a fire when
folded or put away.
^ Check the fluff / lint filter and clean if necessary.
2 Cottons dry
Programme finished
Check lint filter
A reminder will appear in the display when the filter
need to be cleaned. The filter should be cleaned as
soon as the programme finishes.
Drying
Ready at 12:35
FC
K f
A
13