Accessories; Installation; Assembling The Exhaust Duct. First Extend; End Plate Placement - Sealey sac9000.V3 Instruction Manual

3. ACCESSORIES

A. . . . . . . . . . . . . . . . . . . . . . . END PLATE ADAPTOR
B . . . . . . . . . . . . . . . . . ExHAUST DUCT (MAx. 1.5M)
C . . . . . . . . . . . . . . . ExHAUST DUCT CONNECTOR
fig.2

4. INSTALLATION

4.1. Assembling the exhaust duct. (See fig.2B) First extend
each end of the duct (B) as shown above and attach the
end plate adaptor (A) to one end using an anticlockwise
threading action. Attach the other end of the duct to the
exhaust duct connector (fig.2.C) on the back of the unit,
having slid the connector onto the exhaust (fig.3). The
exhaust duct can be extended up to 1.5m. The unit is at its
most efficient when the exhaust duct is kept as short as
possible. Use only the duct supplied. Do not further extend
the length of the duct with other ducting as this will reduce the
efficiency of the unit.
4.2. End Plate placement. Identify a suitable window which can be opened vertically or horizontally.
Match the window opening to the height of the end plate. Slide the inner part of the end plate out until it matches
the width of the window and lock the two parts together by tightening the screws on the inside edge of the inner
slide. Permanently screw the end plate to the window frame or make a semi permanent installation using
re-inforced, high tack, adhesive tape. Bring the unit close to the window and push the end plate adaptor at the
end of the duct into the matching hole in the end plate. Fig.5 shows the unit installed by a horizontally opening
window. Keep the duct as short as possible but do not allow the duct to be kinked or distorted or blocked as this
will overheat the unit. If the unit becomes overheated it will automatically shut down.
© Jack Sealey Limited
D . . . . . . . . . . . . . . . . . . . . . . . . .REMOTE CONTROL
E . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .END PLATE
fig.4
Original Language Version
fig.3
SAC9000.V3 Issue: 4(I) - 11/02/14