Stihl MS 362 C-Q Instruction Manual page 29

Holding the chain saw
There are two ways to hold the chain
saw during starting.
On the ground
Place the chain saw securely on the
N
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
With the left hand on handlebar,
N
press the chain saw firmly against
the ground – thumb wrapped
around the handlebar
Place your right foot through the
N
rear handle
MS 362 C-Q
Between the knees or thighs
clamp the rear handle between the
N
knees or thighs
grip the handlebar firmly with the left
N
hand – thumb wrapped around the
handlebar
Starting
with the right hand, pull the starter
N
grip slowly until you feel it engage –
and then give it a brisk strong pull –
simultaneously press down on the
handlebar – do not pull the starter
rope out all the way – risk of
breakage! Do not let the starter grip
snap back – guide it slowly back into
the housing so that it can rewind
properly
With a new engine or after a long period
of disuse, with machines without an
additional manual fuel pump, it may be
necessary to pull the starter rope several
times - to prime the fuel line.
English
27