Rheem 96v series Installation Instructions Manual page 21

NOTE: REMAINING STEPS SHOWN WITH FURNACE IN DOWN FLOW ORIENTATION
6
1/4" TUBE CUT
TO FIT (APPROX
10-1/2")
6c
6b - INSTALL CONDENSATE TRAP BY MOUNTING BRACKET TO JACKET USING (2) SCREWS
6c - CUT 1/4" VENT TUBE TO FIT (APPROX. 10-1/2"). INSTALL AS SHOWN.
6d - INSTALL HOSE D (REMOVED IN STEP 1) FROM INDUCER COUPLING TO THE FLUE
TAP IN THE CONDENSATE TRAP.
6e - INSTALL HOSE E FROM COLLECTOR BOX TO TOP OF CONDENSATE TRAP.
7 OPTION: LEFT DRAIN
1/8" DRILL
DISCARD
7/8" PLUG
DETERMINE RIGHT OR LEFT DRAIN OPTION.
LOCATE 7/8" HOLE IN JACKET SIDE AND REMOVE PLUG - DISCARD.
DRILL (2) 1/8" HOLES FOR BULKHEAD COUPLING.
9a
OPTION
TUBE C
DRAIN LEFT SIDE
CUT TO FIT
CABINET WIDTH
ATTACH SIDE "2" TO BULKHEAD
COUPLING
2
1
TUBE C
9a - LEFT SIDE DRAIN OPTION.
9a-1 - REMOVE HOSE "A" (FACTORY INSTALLED) ON CONDENSATE TRAP & REPLACE
WITH HOSE "B" REUSING SUPPLIED CLAMP.
9a-2 - CUT TUBE "C" ON MARKED LINES CORRESPONDING TO CABINET WIDTH.
9a-3 - SLIDE (2) WIRE CLAMPS OVER TUBE "C" AND (1) WIRE CLAMP OVER
SIDE "2" OF HOSE-DOUBLE ELBOW.
9a-4 - CONNECT HOSE - DOUBLE ELBOW END "1" TO TUBE "C", CONNECT END
"2" TO BULKHEAD COUPLING. CONFIRM ALL (4) CLAMPS ARE PLACED
CORRECTLY.
SEE CRITICAL HOSE CLAMP LOCATION NOTE
IN THE GENERAL COVERSION INSTRUCTIONS.
6e
HOSE E
6d
HOSE D
OPTION: RIGHT DRAIN
1/8" DRILL
DISCARD
7/8" PLUG
9b
HOSE B
(X3)
NOTE: PLIERS NECCESSARY TO ADD OR REMOVE CLAMPS
APPROXIMATELY 10-20° TILT
6a
ON INDUCER COUPLING
ROTATE INDUCER COUPLING TO ENSURE
DOWNWARD FLOW OF CONDENSATE FROM
FLUE VENTING
6b
NOTE:
USE SOAPY WATER TO FACILITATE EASY
HOSE AND TUBE ASSEMBLY
8
INSTALL
INSTALL BULKHEAD COUPLING USING (2) SCREWS.
INSTALL IN JACKET WITH THE BARBED FITTING
POINTED INTO THE VESTIBULE.
OPTION
DRAIN RIGHT SIDE
9b - RIGHT SIDE DRAIN OPTION
ATTACH HOSE A (FACTORY INSTALLED) TO BULKHEAD COUPLING.
GROUND
10° -20
HOSE A
ST-A1194-30-02
21