Night Light Dimmer Control; Continuous Pilot / Intermittent Pilot (Cpi / Ipi) Selection; Key Lock - Napoleon NDX40NT-2 Installation And Operating Instructions Manual

9.6

NIGHT LIGHT DIMMER CONTROL

The auxiliary function controls the Night Light
dimmable control.
A. Use the Mode Key to guide you to the Night
Light icon.
B. The intensity of the output can be adjusted
through 6 levels. Use the UP/DOWN arrow
keys to adjust the output level. A single beep will
confi rm reception of the command.
9.7

CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTION

A. Use the Mode Key to guide you to the CPI mode
icon. Transmitter in the OFF position.
B. Press the UP/DOWN to switch between IPI and
CPI modes. A single BEEP will confi rm reception
of the command.
Note: If the system is equipped with a CPI/IPI
toggle switch, set the CPI/IPI to CPI position to
enable remote CPI operation. If the switch is set
to IPI then it will only work in IPI regardless of
what is set on the remote control handset.
9.8

KEY LOCK

This function will lock the keys to avoid unsupervised operation.
A. Press the MODE and UP keys at the same time.
B. To de-activate this function, press the MODE and UP keys at the same time.
with
TM
76
OFF
76
IPI
41
76
°F
35.21
76
°F
CPI
35.22
76
35.10A
W415-1596 / 11.25.15
°F
EN
°F
°F