dji Mavic pro User Manual page 7

Marked
Unfold the Arms
1. Unfold the front arms, followed by the rear arms of the aircraft as shown.
2. Unfold all propeller blades.
Unfold the front arms and the propellers before the rear ones. All arms and propellers must be
unfolded before takeoff.
Preparing the Remote Controller
1. Unfold the mobile device clamps and the antennas.
2. Choose an appropriate RC cable based on the type of mobile device used. An RC cable with a
Lightning Connector has been connected and the Standard Micro USB connector cable and the USB
Type-C connector cable are included. An optional Reverse Micro USB connector cable is available.
Insert the mobile device and secure it.
Refer to the figure below for how to replace the RC cable.
Ensure the Control Mode Switch is toggled to "RC" when using the Remote Controller to control
the aircraft.
To connect your mobile device to the remote controller using a USB cable, plug one end of the cable
into your mobile device and the other end into the USB port on the bottom of the remote controller.
Unmarked
1
Lightning Connector
USB Type-C Connector
The RC cable slider must be replaced if
using a USB Type-C RC cable.
©
Mavic Pro User Manual
Micro USB Connector
Reverse Micro USB
Connector
2016 DJI All Rights Reserved.
7