dji Mavic pro User Manual page 23

Calibrating Sensors
Forward and Downward Vision Systems cameras installed on the aircraft are calibrated on delivery.
However these cameras are vulnerable to excessive impact and will require occasional calibration
via DJI Assistant 2 or the DJI GO app. Follow the steps below to calibrate the camera.
01
Point the aircraft toward the screen
Repeat the steps above to calibrate the Downward Vision System cameras.
Quick Calibration
Use quick calibration when the DJI GO app notify that vision sensor calibration is required. Tap through
"Aircraft Status" -> "Vision Sensors" to start quick calibration.
Quick calibration is quick fix to vision sensor issues. Connecting the aircraft to a computer to
carry out a full calibration using DJI Assistant 2 is recommended when possible. Only calibrate
when lighting conditions are adequate and on textured surfaces i.e. grass.
Do not calibrate the aircraft on highly reflective surfaces such as Marble or ceramics.
Using the Downward Vision System
The Downward Vision System is activated automatically when the aircraft is turned on. No further
action is required. The Downward Vision System is typically used in indoor environments where
GPS is unavailable. Using the Downward Vision System, the aircraft can hover precisely even with-
out GPS.
Follow the steps below to use Downward Vision System:
1. Toggle the flight mode switch to P-mode.
2. Place the aircraft on a flat surface. Note that the Downward Vision System cannot work
properly on surfaces without clear pattern variations.
3. Turn on the aircraft. The aircraft status indicator will flash green two times, which
indicates the Downward Vision System is ready. Gently push the left stick up to lift
off and the aircraft will hover in place.
02
Align the boxes
Mavic Pro User Manual
03
Pan and tilt the aircraft
SPORT
©
2016 DJI All Rights Reserved.
23