Table of Contents
Advertisement
Let your left hand glide over the bridge guard/guide to the outfeed side of the cutter head
being sure to keep your hands a safe distance from the cutter head.
As soon as it is possible, use both hands to continuously push the workpiece on the
outfeed side of the table.
11.
If you are not going to continue working, switch off the machine and secure it against being
turned on again accidentally.
Beveling/Chamfering
1.
Disconnect and lockout power to the machine!
2.
Verify the machine has been completely changed to
jointer operation. See "Changeover from a Planer to
a Jointer".
3.
Set the fence to the desired angle between 90° and
45°.
4.
Position the fence to provide enough width for the
material.
Adjusting the depth of cut to not more than 1/16"
5.
(1.5mm).
6.
Adjust the bridge guard:
Place the workpiece against the fence and push
it forward to the end of the table but not over the
cutterblock.
Loosen the clamping screw (2) and move the
guard/guide (3) to be 3/8" (10mm) from the
workpiece.
Tighten the clamping screw.
Use the setscrew (1) to adjust the guard/guide (3) to approximately 3/8" (10mm) above
the table.
7.
Clear the jointer table of any tools or material.
8.
Position push blocks/sticks within easy reach for feeding the workpiece.
9.
Turn the machine ON.
10.
Position the workpiece on the infeed table and take a position next to the table that will allow
for safely feeding the workpiece across the cutter head.
11.
Machining the workpiece:
36
36
Advertisement
Table of Contents
