Table of Contents
Advertisement
SAFETY PRECAUTIONS (cont.)
28.
Kickback Zone. The path directly behind the end of the in-feed table is referred to as the
"Kickback zone". NEVER stand or allow others to stand in this area while the machine is
running. Position yourself to one side of the machine while the jointer/planer is running.
29.
Using Quality Stock. Inspect the stock over carefully that you intend to joint or plane.
NEVER joint or plane a board that has knots, staples, or nails in it. DO NOT joint or plane a
piece of stock if you have any doubts about its structural integrity.
30.
Remove any adjusting tools. Before operating the machine, make sure any adjusting tools
have been removed.
31.
Support the piece part. Supporting the piece part adequately while cutting, is crucial to
making safe cuts and avoiding possible operator injury.
32.
Proper cutting. While cutting, always keep the piece part moving towards the out-feed table
until it has completely passed over the cutterhead. NEVER back the piece part toward the in-
feed table.
33.
Dull / Damaged Knives. Use only sharp, undamaged knives to avoid unnecessary kickback
of the piece part. Dull and damaged knives will also affect cut quality.
Maximum Cutting Depth. The maximum cutting depth for one pass is 1/8" (3.2mm). Never
34.
set the machine to cut deeper than this in one pass.
35.
Grain Direction. There is an increased chance of kickback when jointing or planing end
grain or against the grain. This could also produce chatter and excessive chip out of the
material.
36.
Observe work area conditions. DO NOT use machines or power tools in damp or wet
locations. Do not expose to rain. Keep work area well lighted. DO NOT use electrically
powered tools in the presence of flammable gases or liquids.
37.
Cutterhead Alignment. Keep the top edge of the out-feed table aligned with the cutterhead
knife at top dead center (TDC). This will help to avoid kickback and possible operator
injuries.
38.
Clearing Chips and Debris. Chips and dust build-up can present an injury hazard and
affect the cut. Turn the machine OFF, allow the tooling to cool, and vacuum away the debris.
39.
Feeding the Piece Part. ALWAYS feed the piece part against the rotation of the cutter.
NEVER force materials through the shaper. Excessive force against the shaper cutter will
cause dangerous kickback conditions and can result in poor cuts.
40.
Hand Positioning. NEVER place hands directly over or in front of the cutter. ALWAYS keep
hand at least 6" (150mm) away from the cutter while operating.
9
9
Advertisement
Table of Contents
