PeakTech 1020 Operation Manual page 30

Digital - multimeter
Hide thumbs Also See for 1020:
Table of Contents

Advertisement

Available languages

Available languages

6.1. Battery Replacement
Follow these steps to install the battery:
*
Turn off the power and disconnect all test leads.
*
Remove the screw on the bottom case
*
Remove the battery-cover and remove the old batteries
*
Place the new batteries into the battery-compartment.
*
Replace the cover and secure it with the screw.
Note:
Batteries, which are used up dispose duly. Used up batteries are hazardous
and must be given in the for this being supposed collective container.
Statutory Notification about the Battery Regulations
The delivery of many devices includes batteries, which for example serve to
operate the remote control. There also could be batteries or accumulators
built into the device itself. In connection with the sale of these batteries or
accumulators, we are obliged under the Battery Regulations to notify our
customers of the following:
Please dispose of old batteries at a council collection point or return them to a
local shop at no cost. The disposal in domestic refuse is strictly forbidden
according to the Battery Regulations. You can return used batteries obtained
from us at no charge at the address on the last side in this manual or by
posting with sufficient stamps.
-29-

Advertisement

Table of Contents
loading

Table of Contents