Page 1
Desktop SSHD Product Manual ST4000DX001 ST2000DX001 ST1000DX001 100726566, Rev. K May 2016...
Page 2
Seagate, Seagate Technology and the Swirl logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Seagate AcuTrac, OptiCache, SmartAlign and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners.
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM, Distribution partner and reseller portals, visit: http://www.seagate.com/partners/ Seagate Desktop SSHD Product Manual, Rev. K...
• Native Command Queuing with command ordering to increase performance in demanding applications • Quiet operation • Seagate AcuTrac™ servo technology delivers dependable performance, even with hard drive track widths of only 75 nanometers. • Seagate OptiCache™ technology boosts overall performance by as much as 45% over the previous generation.
12V: +10% / -7.5% Non-Operating (Ambient °C) –40° to 70° Operating ambient temperature (min °C) 0° Operating temperature (Drive case max °C) 60° 20°C per hour max (operating) Temperature gradient 30°C per hour max (non-operating) Seagate Desktop SSHD Product Manual, Rev. K...
2000GB 3,907,029,168 ST1000DX001 1000GB 1,953,525,168 *One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. Seagate Desktop SSHD Product Manual, Rev. K...
Internal data transfer rate (Mb/s max) 1TB and 2TB 2147 1813 Maximum sustained data transfer rate, OD read (MB/s 1TB and 2TB Average data rate, read/write (MB/s) 1TB and 2TB I/O data-transfer rate (MB/s max) Seagate Desktop SSHD Product Manual, Rev. K...
(such as track-to-track and average), are expected to meet the noted values. However, due Note to the manner in which these drives are formatted, benchmark tests that include command overhead or measure logical seeks may produce results that vary from these specifications. Seagate Desktop SSHD Product Manual, Rev. K...
10MHz. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. Note 2.8.3 Voltage tolerance Voltage tolerance (including noise): • 5V ±5% • +10% / -7.5% Seagate Desktop SSHD Product Manual, Rev. K...
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive accepts all com- mands and returns to Active mode when disk access is necessary. Seagate Desktop SSHD Product Manual, Rev. K...
3.0 bels (max) 2.7 bels (max) 2.5 bels (max) *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Desktop SSHD Product Manual, Rev. K...
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules.
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging.
For installations which require cables, users can connect the drive as illustrated in Figure 2 Figure 2 Attaching SATA cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Desktop SSHD drives support latching SATA connectors. Seagate Desktop SSHD Product Manual, Rev. K...
2x 3.740 in 98.25 mm 4x 6-32 UNC-2B 3 MINIMUM THREAD DEPTH 0.12 MAXIMUM FASTENER PENETRATION 2x 0.130 in 3.18 mm 2x 1.625 ± .020 in 2x 1.750 in 41.28 ± .15 mm 44.45 mm Seagate Desktop SSHD Product Manual, Rev. K...
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. • All used voltage pins (V ) must be terminated. Seagate Desktop SSHD Product Manual, Rev. K...
Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Number of sectors transferred during a Read Multiple or Write Multiple command xxxx Seagate Desktop SSHD Product Manual, Rev. K...
Page 27
Total number of user-addressable LBA sectors available (see Section 2.2 for related ST4000DX001 = 7,814,037,168 information). These words are required for drives that support the 48-bit addressing ST2000DX001 = 3,907,029,168 feature. Maximum value: 0000FFFFFFFFFFFFh. ST1000DX001 = 1,953,525,168 Seagate Desktop SSHD Product Manual, Rev. K...
Page 28
160–254 ATA-reserved 0000 Integrity word xxA5 Automatic Acoustic Management (AAM) features are not supported. Note See the bit descriptions below for words 63, 84, and 88 of the Identify Drive data. Note Seagate Desktop SSHD Product Manual, Rev. K...
Page 29
Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate Desktop SSHD Product Manual, Rev. K...
Disable use of SATA features Enable read look-ahead (read cache) feature (default). Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above. Note Seagate Desktop SSHD Product Manual, Rev. K...
S.M.A.R.T. Enable Operations S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x04 (abort) is written to the Error register. Seagate Desktop SSHD Product Manual, Rev. K...
Page 32
ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100726566, Rev. K...