Suunto ZOOP User Manual page 51

Hide thumbs Also See for ZOOP:
Table of Contents

Advertisement

power gets too low. When this happens, the instrument should not be
used until the battery has been replaced.
Do not fasten the strap of your dive computer too tightly. You should be
able to insert your finger between the strap and your wrist. Shorten the
strap by cutting it if you do not expect to need the extra length.
MAINTENANCE
The instrument should be soaked, thoroughly rinsed with fresh water, then
dried with a soft towel after each dive. Make sure that all salt crystals and
sand particles have been flushed out. Check the display for possible mois-
ture or water. DO NOT use the dive computer if you detect any moisture or
water inside. Contact an authorized Suunto dealer for battery replacement
or other service.
Do not use compressed air to blow water off the unit.
Do not use solvents or other cleaning fluids that might cause damage.
Do not test or use the dive computer in pressurized air.
WATER RESISTANCE INSPECTION
The water resistance of the unit must be checked after replacing the battery
or after other service operations. The check requires special equipment and
training. You must frequently check the display for any sign of leaks. If
you find moisture inside your dive computer, there is a leak. A leak must be
corrected without delay as moisture will seriously damage the unit, even be-
yond repair. SUUNTO does not take any responsibility for damage caused
by moisture in the dive computer unless the instructions of this manual are
carefully followed. In the event of a leak, immediately take the dive com-
puter to an authorized SUUNTO dealer or distributor.
FAQs
WHAT CAN I DO TO MY SUUNTO DIVING COMPUTER MYSELF?
NOTE! It is advisable to contact an authorized Suunto service, distributor or
retailer for any repairs. Batteries and straps can be replaced by the user when the
change is made in a proper manner to avoid any leakage of water into the battery
compartment or computer. Original battery replacement and strap kits must be
used.
Batteries can be changed by the user in all diving computers except Stinger, D4,
D6 and D9. Instructions for changing batteries and straps can be found in the user
manuals or at www.suunto.com and the user videos there.
CAUTION!
49

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents