Power Switch - Bissell 82G7 SERIES User Manual

_sembly
Attach vacuum hose and tools 1-2.
1. Line up the tabs on the base of the Twist
'n Snap hose with the corresponding
notches on the hose collar asshown-. Twist 'n
2. Turn the Twist 'n Snap hose to the left
to lock the hose into place.
.
.
5.
Connect the curved hose wand to the
hose. Grasping the curved hose wand,
slide the end of the curved hose wand
onto the hose wand base. Snap the hose
into the hose clip.
NOTE: The vacuum will not operate Dusting Brush/
effectively unless the curved hose wand Upholstery
is firmly attached.
Slide the extension wand and crevice tool Crevice
together into the storage clip. Extension Wand-
Slide the dusting brush/upholstery tool Curved
into the storage clip. Wand
.
Store TurboBrush on the front of the han-
dle by lining up the TurboBrush base with
the base of the holder then push back to
snap into place.
Hose Wand
Power switch
The power switch is located just below
the handle on the front of thevacuum.
Push the rocker switch "ON" (I) to
vacuum, and "OFF" (O) when cleaning
is complete.
/ CAUTION:
Before using your vacuum, make
sure that the dust bag and all filters
(pre-motor and post-motor)are in
place. Do not operate your vacuum
without the dust bag and filters.
NOTICE:
Forabove floor cleaning,the floor brushwill
continueto rotatebut is raisedabove floor.
Topreventcarpetdamage, do not lean on
the vacuum or let the powerfoot tilt forward.
/K CAUTION:
Toavoid personalinjury and to
preventthe cleanerfrom falling
when cleaning stairs,always
place it at the bottomof the stairs.
w. b i s s e II .co m y_, 8 00. 2 3 7.7 6 9