Adjusting The Speaker Output Levels Using A Test Tone; Using The Time Alignment - Pioneer AVH-P6600DVD Operation Manual

Section
15 Digital Signal Processor
3 Touch or
be adjusted.
Each time you touch
speaker in the following order:
FRONT-L (front speaker left)CENTER (center
speaker)FRONT-R (front speaker right)
REAR-R (rear speaker right)REAR-L (rear
speaker left)SUB WOOFER (subwoofer)
# You cannot select speakers whose size is set
at OFF.
4 Touch or
output level.
Each time you touch
creases the speaker output level. +10  10 is
displayed as the level is increased or de
creased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
TEST TONE. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
78
En
to select the speaker to
or selects the
to adjust the speaker
or increases or de
FRONT-L (front speaker left)CENTER (center
speaker)FRONT-R (front speaker right)
REAR-R (rear speaker right)REAR-L (rear
speaker left)SUB WOOFER (subwoofer)
Check each speaker output level. If no adjust
ments are needed, perform step 5 to stop the
test tone.
# You can also start the test tone output by mov
ing the joystick up.
# The settings do not appear for speakers
whose size is set OFF.
4 Touch or to adjust the speaker
output level.
Each time you touch
creases the speaker output level. +10  10 is
displayed as the level is increased or de
creased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
5 Touch STOP to stop the test tone out-
put.
# You can also stop the test tone output by mov
ing the joystick down.
Notes
! If needed, select speakers and adjust their ab
solute output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out
put levels at SPEAKER LEVEL. Both provide
the same results.

Using the time alignment

Only when the multi-channel processor (e.g.,
DEQ-P8000) is connected to this unit, you can
operate this function.
or increases or de