Selecting A Cut Off Frequency; Adjusting The Speaker Output Levels - Pioneer AVH-P6600DVD Operation Manual

Digital Signal Processor
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch SPEAKER SETTING.
3 Touch or to select SUB WOOFER
(subwoofer).
Each time you touch
speaker in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)PHASE (sub
woofer setting)
4 Touch to turn subwoofer output on.
# To turn subwoofer output off, touch
5 Touch and then touch
lect the phase of subwoofer output.
Touch to select normal phase and
NORMAL appears in the display. Touch
select reverse phase and REVERSE appears in
the display.
Note
When playing a 2 channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
! No audio is output if the center speaker set
ting is SMALL or LARGE and no center speak
er is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.
Selecting a cut-off frequency
You can select a frequency, under which
sounds are reproduced through the subwoo
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro
or selects the
.
or to se-
to
duced through a LARGE speaker or subwoo
fer.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch CROSS OVER.
3 Touch or to select the speaker to
be adjusted.
Each time you touch
speaker in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)
4 Touch or to select cut-off fre-
quency.
Each time you touch
frequencies in the following order:
6380100125160200 (Hz)
Note
Selecting a cut off frequency is to set a cut off fre
quency of the subwoofers L.P .F. (low pass filter)
and that of the SMALL speaker H.P.F. (high pass
filter). The cut off frequency setting has no effect
if the subwoofer is set to OFF and other speakers
are set to LARGE or OFF.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch SPEAKER LEVEL.
or selects the
or selects cut off
En
Section
15
77