Adjusting The Speaker Output Levels; Selecting A Cross-Over Frequency; Adjusting The Speaker Output Levels Using A Test Tone - Pioneer Super Tuner III D AVH-P4050DVD Operation Manual

Available accessories
Note
When playing a 2-channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SMALL or LARGE and no center
speaker is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Touch NEXT on the DSP function menu.
2 Touch SPEAKER LEVEL.
3 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
FRONT L (front speaker left)—CENTER (center
speaker)—FRONT R (front speaker right)—
REAR R (rear speaker right)—REAR L (rear
speaker left)—SUB WOOFER (subwoofer)
# You cannot select speakers whose size is set
at OFF. (Refer to Setting the speaker setting on
the previous page.)
4 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level. +10 to –10 is
displayed as the level is increased or de-
creased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
TEST TONE. Both provide the same results.

Selecting a cross-over frequency

You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro-
duced through a LARGE speaker or subwoo-
fer.
1 Touch NEXT on the DSP function menu.
2 Touch CROSS OVER.
3 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—
SUB WOOFER (subwoofer)
4 Touch c or d to select cross-over fre-
quency.
Each time you touch c or d selects cross-over
frequencies in the following order:
63Hz—80Hz—100Hz—125Hz—160Hz—
200Hz
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer's L.P .F. (low-pass
filter) and that of the SMALL speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to OFF and other
speakers are set to LARGE or OFF.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Touch NEXT on the DSP function menu.
2 Touch TEST TONE.
Section
04
71
En