Using Subwoofer Output; Using Nonfading Output; Using The High Pass Filter - Pioneer AVH-P6600DVD Operation Manual

Audio Adjustments
1 Touch A.MENU and AUDIO and then
touch LOUDNESS.
2 Touch to turn loudness on.
# To turn loudness off, touch
3 Touch or to select a desired level.
Each time you touch
the following order:
LOW (low)MID (mid)HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
! When the subwoofer output is on, you can
adjust the cut off frequency and the output
level of the subwoofer.
1 Touch A.MENU and AUDIO and then
touch SUB WOOFER.
# When the subwoofer controller setting is
FULL, you cannot select SUB WOOFER.
2 Touch to turn subwoofer output on.
# To turn subwoofer output off, touch
3 Touch and then touch
lect the phase of subwoofer output.
Touch to select normal phase and
NORMAL appears in the display. Touch
select reverse phase and REVERSE appears in
the display.
4 Touch and then touch
just the output level of the subwoofer.
Each time you touch
creases the level of the subwoofer. +6  6 is
displayed as the level is increased or de
creased.
.
or selects level in
.
or to se-
to
or to ad-
or increases or de
5 Touch and then touch
lect cut-off frequency.
Each time you touch
frequencies in the following order:
50Hz80Hz125Hz
Only frequencies lower than those in the se
lected range are outputted from the sub
woofer.

Using nonfading output

When the nonfading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out
putted through the RCA output.
1 Touch A.MENU and AUDIO and then
touch NON FADING.
# When the subwoofer controller setting is only
FULL, you can select NON FADING. (Refer to
page 89.)
2 Touch to turn non fading output on.
# To turn non fading output off, touch
3 Touch or to adjust the output
level of the non fading.
Each time you touch
creases the level of the non fading. +6  6 is
displayed as the level is increased or
decreased.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
or to se-
or selects cut off
.
or increases or de
En
Section
14
69