Monitor Section - Panasonic WR-DA7 User Manual

MONITOR Section

12
MONITOR A source
selection buttons
MONITOR B source
selection buttons
Talkback ON LED
button
The DA7 provides controls for two monitor outputs and a talkback circuit.
There are source selection LED buttons for the MONITOR A and MONITOR
B outputs, and LEVEL knobs for both of the monitor outputs and the
talkback circuit.
MONITOR A Controls
The MONITOR A selection LED buttons route the input selected (green) to
the MONITOR A OUTPUT (CR) (Control Room) connections on the Rear
Panel of the mixer and to the headphones. The selections are:
L/R routes the MASTER L/R output to the monitors.
2TR A routes the device that is connected to 2TR A IN on the Rear
Panel to the monitors.
2TR B routes the device that is connected to 2TR B IN on the Rear
Panel to the monitors.
AUX routes the AUX SEND outputs to the monitors. Press the AUX
LED button to monitor the selections, beginning with AUX SEND 1/2,
followed by AUX SEND 3/4, and AUX SEND 5/6. The MEMORY
numeric readout on the Display Bridge will momentarily display the
AUX SEND selections.
The MONO button, when on (red), sums the selected input and sends a
monaural signal to the monitors. This will not affect the 2TR B output
stereo signal.
-
2 1 5
L/R 2TR A 2TR B
MONITOR
MONO
AUX
A LEVEL
0 10
MONITOR A
MONITOR A L/R AUX
MONITOR
B LEVEL
0 10
MONITOR B
ON
T. B.
LEVEL
0 10
TALK BACK
MIC
MONITOR Section
C h a p t e r 2
LEVEL knobs
D A 7 U s e r s ' G u i d e