Connections
Please take the following steps to install the SMPTE/V SYNC card. See
illustration above.
Loosen the 4 screws, and then remove the blank panel of the SMPTE/V
1
SYNC slot.
Bend one end of the accessory cable of the WR-SMPT card, so that the
2
conductive surface becomes exposed as in the illustration.
Connect the bent end of the cable, as shown, to the DA7.
3
Connect the other end of the cable to the WR-SMPT, so that the
4
conductive surface is in the up position, as shown.
After making sure that the conductive surface of the accessory cable is
5
facing up, insert the card carefully and fasten the 4 removed screws.
-
17
1 0
C h a p t e r 1 7
WR-SMPT
D A 7 U s e r s ' G u i d e