Tandem Card, Wr-Tndm - Panasonic WR-DA7 User Manual

17-6 TANDEM Card, WR-TNDM

Tandem Connection Card
The TANDEM card is for use only with SLOT 3 on the Rear Panel of the DA7.
SLOT 3 has the options of [NORMAL], [INS], or [TANDEM] mode. When
button is selected, the SLOT 3 column of the [D-I/O>TO SLOT]
the
window changes to recognize which option card is in the slot. When you
assign [TANDEM] on or off, a data field in the window will confirm
connection. Another data field is used to program an [OFFSET DELAY]
value to the slave DA7.
TANDEM Connection
This diagram shows how to connect two DA7s with four DA88s, with a DA88
operating as the Master Clock source.
SYNC IN
I/O
DA88 ID2
SYNC OUT
SYNC IN
I/O
DA88 ID3
SYNC OUT
WR-
(need terminator)
TDIF
MIDI OUT
MIDI IN
S/PDIF/ I/O
EFX Device
SLAVE
WCK IN
Connections
Insert a TDIF option card into both SLOT 1 and SLOT 2. Carefully screw
these cards into their respective slots in the DA7 so they are properly
grounded. The DA88 8-track signal from SLOT 1 is assigned to inputs 17-24.
The DA88 8-track signal from the SLOT 2 card is assigned to inputs 25-32.
-
17 1 1
TANDEM CONNECTION I/O
TANDEM Connection Card
SYNC OUT
I/O
DA88 ID1
SYNC IN
WCK master
SYNC OUT
I/O
DA88 ID0
(SY88
option)
WCK OUT
WR- WR-
TDIF TNDM
MTC MMC
WCK IN
DA7
EFX Device
S/PDIF/ I/O
DAT
AES/EBU I/O
TANDEM CONNECTION GRAPHIC
C h a p t e r 1 7
WR-TNDM
SLAVE MASTER
SP
WR- WR- WR-
Power amp
TDIF TDIF TNDM
MIDI OUT
MIDI IN
CR Monitor out
DA7
PC
MASTER
TO PC
WCK OUT
D A 7 U s e r s ' G u i d e
SP