Advertisement
Upon entering the Programming Mode, the system is immediately set to allow adjustment of the First
Programmable Feature. That First feature, "Passive or Active Arming", can then be set ON or OFF by pressing
button 1 of the transmitter. The system confirms that it is set to adjust the First feature by repeatedly flashing the
LED once, with a pause in between each flash. The system will then report how the feature has been set by the
number of chirps heard after pressing the transmitter button. Toggling the Valet/Program/Manual Override
Switch once again will advance you to the Second Programmable Feature, confirmed by a repeating two LED
flashes, with a pause in between each flash, etc., etc.
It is important to note that when you first enter the Programming Mode, you are automatically positioned to adjust
the First Programmable Feature, and that the Valet/Program/Manual Override Switch allows you to toggle from
there through each of the six more programmable features. However, it will not allow you to return to any feature
once you have toggled past it. Should you accidentally toggle past the feature you wanted to program, you must
exit and re-enter the Programming Mode and then adjust the feature you missed.
It is also important to note that you may toggle past as many programmable features as you wish without having
to adjust them. Each time you toggle forward to a new feature, the siren will chirp the appropriate number of
times (1, 2, or 3 times) to indicate how that feature is currently set, and the LED will flash the appropriate number
of times to indicate the number of the feature (First through Seventh) that you are set to adjust. For example, you
might enter the mode and toggle the Valet/Program/Manual Override Switch 3 times in order to adjust the Fourth
programmable feature. The system would respond with 1 Chirp, and the LED would begin to flash 4 Flashes,
pause, and repeat. This has told you that the system is ready for you to adjust the Fourth programmable feature,
and that it is currently programmed for Chirps ON. A single press of button 1 of the transmittter will cause the
system to produce 2 Chirps. This signifies that you have changed the programming to Chirps OFF. Please
follow the programming procedure on the next page, and refer to the list of the Programmable Features above
when programming the PRO 9845.
6
Advertisement
