Power Supply; Lcd Display - AOR ard300 User Manual

Power supply

ARD300 requires a (non-supplied) 12V DC power supply of minimum 450mA.
Use the supplied "open-end" DC cable to connect ARD300 to your power supply.
However, when used in combination with the AOR AR8600MK2、AR2300、AR5001D、
AR6000 receivers, the supplied DC cable allows ARD300 to share the receiver's AC
adapter. In that case ARD300 is able to detect the receiver's ON/OFF state and
switches itself ON whenever the receiver is ON.
CAUTION when sharing the AR5001D/6000 power supply:
To switch the receiver ON or OFF, be sure to use the receiver's FRONT PANEL
power switch, rather than the back panel's main power switch. ARD300 could be
damaged by the important power fluctuations when the back panel's main power
switch is used.
ARD300 device settings back-up:
Device settings such as receiver, volume level, digital mode and confidential code
selection are saved in the device's internal memory. ARD300 will be in the same
state when switched ON, as it was before being switched OFF.
CAUTION: Settings might not be saved correctly when ARD300 is not powered OFF
in the proper way, such as when the power supply is suddenly interrupted.

LCD display

At lower temperatures, the LCD might respond slower than usual, this is not a
malfunction.
3