To Read Before Use; Supplied Accessories; Compatible Aor Receivers; Compatibility With Non-Aor Receivers - AOR ard300 User Manual

2. To read before use

Supplied accessories

1. DC cable
For power sharing, when the receiver used is either AR8600MK2,
or AR2300/5001D/6000.
2. DC cable (open-end)
Use this cable to connect ARD300 to your own power supply; in
case ARD300 cannot share power with the receiver.
3. IF cable
4. Audio cable
5. Printed user manual

Compatible AOR receivers

AR8600MK2
AR5000
AR5000A
AR5000A+3
AR-ONE
AR2300
AR5001D
AR6000

Compatibility with non-AOR receivers

ARD300 supports any other brand's receiver featuring a 10.7MHz or 45.05MHz I.F
output, under following conditions:
-I.F carrier-to-noise floor ratio must be sufficient for good quality decoding. Ideal value
approximately 100dBc/sec.
-Receiver step size should be set at 6.25kHz to avoid frequency mismatch.
-Tuned frequency should not be more distant than 1kHz from received signal, for error
free decoding.
Not all 3rd party receivers have been tested. Some receivers might be incompatible for
unknown reasons.
The quality of the digital voice decoding does depend on the receiver's sensitivity.
AOR support is limited to use with AOR receivers.
2
１
１
１
１
１