Panasonic AG-MX70 Operating Instructions Manual page 43

Effect-by-effect setting screens
In the key learn editing mode, the key frame number is displayed in [K Frame].
Using the rotary 1 control, the editing items are selected and key frames are set. Key frames 00 to 19 can be set, and they
are displayed during editing in the rotary 2 control display area.
The time settings for the key frames to date can be set by [ME Time]. This is useful for an additional [KeyFrame]. During
learning, ME is automatically selected for time.
Editing items that can be selected by the rotary 1 control
Insert: A key frame is inserted in the space of the next key frame. Insert is executed using [Enter].
Replace: The current key frame is replaced. Replace is executed using [Enter].
CLR KF: The current key frame is cleared. Clear is executed using [Enter].
Copy: The current key frame is copied. Copy is executed using [Enter].
Paste: The key frame in the copy buffer is pasted by overwriting. Paste is executed using [Enter]. If the key frame has
not been copied, the execution menu cannot be selected.
Exit: Key learn is stored in the memory after exiting the editing mode. Exit is executed using [Enter].
In the editing mode, it is possible to set the parameters using the rotary 2, 3, 4 and 5 controls, XYZ using the joystick XY and
rotary Z control, the aspect ratio using [Aspect], the key frames using [Shift] + rotary 2 control, and the key level using [Shift]
+ rotary 5 control.
To set another key pattern, first exit this screen, proceed with key pattern input again, and execute key learn.
With basic patterns (#3001 to #3006) that can be
positioned and basic compressed patterns (#3301 to
#3304)
R1 R2
Insert
Basic
Replace
CLR KF
K Frame
00
Copy
Paste
Exit
Pos. X 128 Y 128
Z 196
Event ME Time
00 10:00
E
Key
Learn 9000
Insert
Replace Basic
CLR KF K Frame
Copy 00
Paste
Exit
R1 R2
R3 R4 R5
K Level
255
Pattern INT
3013 Wht
F
K Level
R3 R4
With Sphere (#6001)
R1 R2
Insert
Sphere
Replace
CLR KF
K Frame
00
Copy
Paste
Rotate
128
Exit
R2: [Rotate] rotation setting
R4: [Time] setting
R5: [TransF] (transformation) setting
XY Position
3D parameters are the same as with 3DModify.
43
255
R5
R3 R4 R5
K Level
Time TransF
0
255
255