Care And Maintenance - Keystone KSTAP12CG Owner's Manual

Upper filter
(take out)
lower filter B
(take out)
Upper filter
(install)
lower filter B
(install)

CARE AND MAINTENANCE

IMPORTANT:
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
lower filter A
3) Do not wash the unit directly under a tap or using a hose.
(take out)
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
manufacture or its agency.
Fig.23
1. Air filter
- Clean the air filter at least once every two weeks to prevent
inferior fan operation because of dust.
- Removal
This unit has three filters. Take the upper filter out along the
lower filter A
the arrow direction (Fig.23),then take the filter down.
(install)
Take out the lower filter A, then take out the lower filter B.
as shown in Fig.23.
- Cleaning
Wash the air filter by immersing it gently in warm water
Fig.23
(about 40 C/104 F) with a neutral detergent. Rinse the filter
and dry it in a shady place.
- Mounting
Install the upper air filter and the lower filter B, then install
the lower filter A after cleaning (see Fig.24).
2. Unit enclosure
- Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure. Finished by a dry clean cloth.
3. Unit idle for a long time
- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet . Place the open end of the hose
directly over the drain area in your basement floor
(See Fig.20 & 21).
- Remove the plug from the bottom drain outlet, all the water
in the bottom tray would drain out (See Fig.22).
- Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the tape. Remove the batteries from the
remote controller.
- Clean the air filter and reinstall it.
CARE AND MAINTENANCE
O O
14