Power The Drive - Allen-Bradley PowerFlex 753 Quick Start Manual

Step 3: Power Up, Configure the Drive, and Spin the Motor Shaft
Step 3: Power Up, Configure the Drive, and Spin the Motor Shaft
In this step you will power up each of your drives, configure each drive by entering parameter values, and initiate a Static
Tune Autotune routine by using the 7-Class HIM.
If you are not familiar with using a HIM and need additional information, see
PowerFlex 20-HIM-A6 / -C6S HIM (Human Interface Module) User Manual, publication 20HIM-UM001.

Power the Drive

ATTENTION: Power must be applied to the drive to perform the following start-up procedure. Some of the voltages present are at
incoming line potential. To avoid electric shock hazard or damage to equipment, allow only qualified service personnel to perform
the following procedure. Thoroughly read and understand the procedure before beginning.
1. Apply AC power and control voltages to the drive.
2. When prompted, use the
Stopped
0.000 Hz
Select Language to Use
English
Francaise
Espanol
Italiano
Language Selection Screen
3. Press the soft key to select the language.
ENTER
Language selection only applies to new drives. It is not required if the drive has been previously used or when resetting
IMPORTANT
from factory defaults. If this drive was previously powered and configured, and is being repurposed for this application,
reset the drive parameters following the instructions in
4. If either of the screens below display on the HIM, press the
PowerFlex 753 Startup
Start-Up consists of several
steps to configure the drive
Press ENTER
ESC ABORT
ENTER
Main Startup Screen
5. Proceed to Drive Setup on page
12
or to highlight the desired display language.
AUTO
F
▼
ENTER
PowerFlex 753 Startup
Please make a selection
General Startup
OR
Application Specific
Exit Startup
ESC
ABORT ENTER
Startup Screen
13.
Rockwell Automation Publication 750-QS001A-EN-P - March 2015
HIM Overview on page 34
Resetting Factory Defaults on page
ESC soft key until the Main Powerup Screen displays.
Stopped
0.000 Hz
ESC
PowerFlex 753
480V 4.2A
20F...B4P2
00
ESC REF PAR#
PowerFlex 753 Main Powerup Screen
or refer to the
37.
Stopped
AUTO
0.000 Hz
F
PowerFlex 755
480V 4.2A
20G...B4P2
00
TEXT
ESC REF PAR#
PowerFlex 755 Main Powerup Screen
AUTO
F
TEXT