Camera Case; Installing An Anti-Fog Desiccant Pack - Garmin VIRB Ultra 30 Owner's Manual

3
Unhook the back of the latch
4
Open the camera case door

Camera Case

You must perform proper care and maintenance for the camera
case (Caring for the Removable Camera Case, page
Failure to perform proper care and maintenance may cause
damage to the removable camera case or gasket and allow
water to leak into the case during use. Exposing the camera to
water will cause permanent damage to the camera and battery,
which may present a risk of fire, chemical burn, electrolyte leak,
and/or injury.
The included camera case provides rugged protection for your
camera, and it provides water protection when used with the
watersports camera case door.
Two camera case doors are included in the package.
The watersports door is installed on your camera case by
default. The altimeter door
quickly change the camera case door based on your activity.
While the watersports door is installed, the case is water-
resistant up to 40 m and is suitable for many water activities,
including swimming, snorkeling, and high-speed watersports.
The altimeter sensor does not function while the watersports
door is installed.
While the altimeter door is installed, your device records more
accurate elevation and grade data, and additional G-Metrix data,
including jump height and vertical speed. The altimeter door
provides an IEC 60529 IPX7 water rating suitable for rain and
light splashes. The altimeter door is not suitable for watersports,
immersion, or other exposure to water or other liquids.
Go to garmin.com/waterrating
ratings and suitable water activities.
Introduction
.
.
NOTICE
14).
is included in the box. You can
for more information about water
Changing the Camera Case Door
1
Open the camera case door
2
Pull the camera case door away from the camera.
The door releases from the quick-release hinge
3
Align the other camera case door with the quick-release
hinge, and press it toward the camera until it snaps into
place.
4
Verify the gasket is fully seated in the groove.
5
Close and latch the camera case door.

Installing an Anti-Fog Desiccant Pack

Do not eat desiccant packs. Desiccant packs contain silica,
which may cause irritation in your digestive system. Desiccant
packs are harmful if swallowed by an infant or pet and pose a
choking hazard.
For the best clarity and image quality, you should install an anti-
fog desiccant pack to reduce fogging inside the camera case or
on the camera lens. A desiccant pack kit is included in the
product box. Go to www.garmin.com/VIRB
additional desiccant packs.
NOTE: When using the camera case in water or in humid
environments, it is normal for some fog to form inside the case,
especially after the camera has been in use for an extended
time. In very cold or humid environments, some fog may appear
even while the desiccant pack is installed.
1
Open the camera case.
2
Insert the desiccant pack
case.
3 Close and latch the camera case.
Anti-fog Desiccant Pack Storage and Maintenance
• To preserve the effectiveness of the desiccant packs, you
should seal them in the included foil bag when they are not in
use. You should store the included humidity indicator card in
the bag with the desiccant packs.
• If the dots on the humidity indicator card turn green while
stored with the desiccant packs, the desiccant packs are
saturated. When saturated, the desiccant packs lose their
effectiveness, and you should dry them before using them
again.
• If the desiccant packs become saturated, you can heat them
at 85°C (185°F) for 60 minutes to dry them for reuse.
completely.
.
WARNING
to purchase
between the camera and the
3