Page 1
VIRB Series ™ Owner’s Manual September 2013 190-01627-00_0A Printed in Taiwan...
Page 2
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements.
Do not attempt to use the device to charge a battery that was not provided by Garmin. Attempting to charge a battery that was not provided by Garmin can damage the device and void the Installing a Memory Card warranty.
You can also purchase additional mounts for your device, such as wearable mounts, vehicle mounts, or a tripod mount. Go to www.garmin.com/outdoor for more information. NOTE: By default, the camera should be mounted with the screen facing up to record correctly oriented video.
Displays the photo resolution, camera mode, timer count (if set), photos remaining, and number of stored photos. Displays the sensors being used (VIRB Elite only) including Wi-Fi ® , cadence, heart rate, tempe™, and GPS. The sensor icons are gray when disabled, flashing when searching for a signal, and white when enabled or connected.
Recording Video Automatically Tall HD: Use this mode when you need a large, vertical viewing NOTE: This feature is available for VIRB Elite only. area. Tall HD is particularly useful for close-up action shots You can set the device to record video automatically based on and when using a helmet mount.
Before you can connect an external microphone, you must to take a series of time-lapse photos. purchase a Garmin VIRB accessory cable with audio or Select MODE > SETUP > Photos > Self Timer. microphone input. Go to www.garmin.com/outdoor. You must also have an external microphone or audio source with a Select a time interval between photos.
Plug the large end of the cable into an available HDMI port Tracks on the external display. NOTE: This feature is available for VIRB Elite only. The device enters playback mode. You cannot exit playback mode until you disconnect the cable.
Dashboards G-force displays the current g-force acceleration NOTE: This feature is available for VIRB Elite only. maximum g-force A dashboard is a grouping of data fields, charts, or graphs of acceleration data from the device sensors and connected ANT+ sensors.
• Bring the Garmin device within range 3 m (10 ft.) of the www.garmin.com/VIRB or the application store for your mobile ANT+ accessory. device for compatibility information. • After you pair the first time, your Garmin device automatically If necessary, install the Garmin VIRB app from the recognizes the ANT+ accessory each time it is activated.
• .jpeg photo files. About: Displays important software information and your unit • .mp4 video files. • .fit files for exporting to Garmin Connect (output only). Time and Date Settings Connecting the Device to Your Computer Select MODE > SETUP > SYSTEM > Time/Date.
Wi-Fi IEEE 802.11 b/g at 2.4 GHz Getting More Information You can find more information about this product on the Garmin website. • Go to www.garmin.com/outdoor. • Go to www.garmin.com/learningcenter. • Go to http://buy.garmin.com, or contact your Garmin dealer for information about optional accessories and replacement parts.
Index speed 6 storing data 9 system settings 9 accessories 7, 10 ANT+ sensors 3 temperature 6, 9 forgetting 8 time pairing 7 settings 9 zones and formats 9 tones 9 battery 1, 9 tracks 6, 9 charging 1 transferring, files 9 installing 1 troubleshooting 8–10 life 9 unit ID 9 cadence 6 camera mass storage mode 9 field of view 4 transferring files 9 level 3...