Baum 2020 Instruction Manual page 18

Batching Time Adjustment
+
Select Count Source
The batching count source will be the feeder
photoeye.
The batching count source will be whatever is
connected as the delivery photoeye.
Table 8. Count Source Selection
0
2.3 Easy Mode and Continuous Cycle
Mode
2.3.1 Easy Mode and Continuous Cycle Mode
Select Easy Mode
TP10243-1
+
Select Continuous Cycle Mode
+
2.4 Learn Mode
No valid sheet has been read yet, the system is in
Single Sheet mode.
A valid sheet has been read and the DCT500 has
been setup to run. Single Sheet mode is off.
Table 9. Learn Mode Status
PAGE 18