Vivitar DVR 787HD User Manual page 8

1. Power off the camcorder.
2. Connect the smaller end of USB cable into the USB slot on your camcorder.
Connect the other end of the USB cable to the AC Adapter and then plug the AC
Adapter into a power socket. (See figure 2)
3. The charge light will turn off when the battery is fully charged. (See figures 3 and 4)
Battery Indicator:
Battery Indicator
Installing the Micro SD Memory Card
Make sure a Class 4 or higher Micro SD Memory card has been properly inserted into your
camcorder. A Micro SD Card must be inserted before use. Micro SD Memory card not included.
To properly insert the Micro SD Card:
1. Power off the camcorder.
2. Open the Micro SD cover.
3. Insert the Micro SD Card into the Micro SD Card slot in the direction as shown above.
4. Gently press the Micro SD Card until you hear a slight clicking sound. This indicates the
memory card has been inserted correctly.
5. To remove the card, gently press on the edge of the card to release it and pull the card out.
Note: If the card is inserted or removed while the camcorder's power is on, it may damage the
card and/or any recorded data. Always confirm that the power is off before inserting the card
into the camcorder.
Description
The battery level is full.
The battery level is half.
The battery level is low, indicating to prepare for
recharging the built-in lithium battery.
If the no battery level icon shows, the battery is almost
exhausted and the camcorder automatically turns off after
a moments.
7