Two vehicle specific headrests with 7” lcd monitors and built-in dvd player for rear seat entertainment (25 pages)
Summary of Contents for Audiovox CAMSBAR
Page 1
Vehicle Rear Observation System With Integrated Parking Sensors Model: CAMSBAR Installation/User Manual Features: • 2.5" LCD Color Display • 2 Ultra Sonic Rear Obstacle Sensors • On-screen Display Function • Automatically Displays Image when Vehicle is in Reverse • Monitor Mounts on Dash or Windshield •...
TABLE OF CONTENTS Warnings Product Description Packing List Installation Instructions CAMSBAR Installation Monitor Installation Operating the System Testing the System Specifications Maintenance Troubleshooting...
2. You are responsible for ensuring that the installation of this product does not void or affect the vehicle manufacturer’s warranty. Audiovox Electronics Corporation or its subsidiaries are not liable in full or in part for improper installation resulting in loss or damage to your property, or for voiding all or part of the vehicle manufacturer’s warranty.
Product Description The Vehicle Rear Observation System with Integrated Parking Sensors is designed to assist the driver by providing a clear and wide image of the area behind the vehicle whenever the vehicle is shifted into reverse. The system will also alert you to obstructions that could not normally be seen in your blind zone.
Packing List The model CAMSBAR package consists of the following items: 1. 2.5” LCD Monitor Part # 31052030 2. Chrome Camera / Sensor Bar − 1 qty Part # 31052380 3. 2.5m Power / Video Supply Cable − 1 qty Part # 31052160 4.
The CAMSBAR must be placed where the sensors can clearly detect objects behind the vehicle. The best height is between 18 Inches and 30 Inches above the ground.
Page 7
Be sure to leave enough wire to route behind the license plate. 3. Place the CAMSBAR over the license plate and line up the holes. Fasten the CAMSBAR to the license plate using the provided bolts from behind the plate and then fasten the license plate to the vehicle.
Page 8
4. Continue to run the power harness for the CAMSBAR to the vehicle’s reverse lamp. Locate the reverse lamp in the tail light assembly. Generally, the Positive wire on the reverse lamp will be a colored wire and the Negative wire will be black.
Monitor Wiring 1. Using the supplied Monitor Signal Wire, Plug one end into the Power / signal cable from the bar. 2. The monitor signal wire can be routed through the car to your chosen location for the monitor by either removing the trim panels at the foot of the door sill or by tucking the wire behind the trim panels at the roof of the vehicle.
Operating the System The CAMSBAR Vehicle Rear Observation System with Integrated Parking Sensors operates when the vehicle is shifted into reverse. The color monitor will activate and show you the view from the camera in the rear of the vehicle. In addition, the back up sensor system is designed to send out an ultra sonic signal that detects obstructions behind your vehicle for an average of 6 feet.
Keep your system away from excessive moisture, extreme heat or cold. • Occasionally clean the surface of the CAMSBAR with a soft cloth moistened with water or glass cleaner. • Remove snow or ice build up as this may cause the system to issue a false alarm.
Troubleshooting Symptoms The CAMSBAR does not turn on after the vehicle is started and the vehicle is in reverse Backup sensors keep sounding The Monitor Stays on all the time or runs when the vehicle is not in reverse. The monitor is very dark or...