Two vehicle specific headrests with 7” lcd monitors and built-in dvd player for rear seat entertainment (25 pages)
Summary of Contents for Audiovox CCDLF
Page 1
Model CCDLF License Plate Rearview Camera with Non-Reversed Image CCDLF FEATURES: • Built Into License Plate Frame • High Resolution, 1/3” CCD Color Camera • Compact Zinc Alloy Die Cast Body • Waterproof Housing • Waterproof Microphone • Wide Angle View •...
Page 2
CONTENTS ITEM FIGURE LICENSE PLATE WITH NON REVERSED CAMERA CAMERA ANGLE ADJUSTMENT WEDGE THEFT-PROOF SCREWS THEFT-PROOF SCREWS FUSE (1A) CAMERA MOUNTING BOLT ANTI-THEFT ALLEN KEY EXTENSION CABLE DIELECTRIC GREASE PACKET HEAT SHRINK TUBING QUANTITY 128-7729 2 of 8...
Page 3
Color Camera View: Cable Connector End View: 128-7729 3 of 8...
The CCDLF camera has a non-reversed image. This camera can be used with Audiovox LCD rear view mirrors and the LCM45NB. It can also be used with multimedia systems that reverse the backup camera image. Installation. Locate suitable location near the vehicles rear license plate to route the camera cable. The camera cable can be routed through an existing grommet or use a location where a 5/8”...
Page 5
If using Audiovox LCD rearview mirror or LCM45NB, use the extension cable supplied with the monitor. Connect the Camera cable to the extension cable (supplied). Route the extension cable up to the intended monitor. Connect as follows: Black wire- connect to chassis ground...
If you see too much bumper, the downward angle must be decreased. Place the thin edge of the wedge on top between the camera and frame. If you cannot see the bumper at all, the downward angle must be increased. Place the thin edge of the wedge on the bottom between the camera and frame.
Specifications: 1. Image Device : 1/3” CCD with 10 Bit A/D Digital Signal Processor. 2. Signal System: CCDLF NTSC, Standard image. 3. Total Effective Pixels: NTSC:537(H)*505(V). 4. Resolution: Greater than 250,000 pixels Greater than 420 TV Lines. 5. Power source : DC12V 6.