Audiovox TV Cables Install Procedures

INSTALLATION PROCEDURES
~NG CABLE (continued) I
2. Attach the Bead CbaiD to the Two Bead
Connector; Secure beadS by folding down
the metal tabs. The following parts will be
used when installed properly:
Two Bead ConDector, Bead Cb~D,
Bead CbaiD CoDnector, and Bead
CbaiD CoDDector Cover. (Figure 16)
3. Remove clip or pin which retains throttle cable
(and washer if provided) and install Two Bead
Connector on the same side of throttle cable as
the Cable Assembly will be anchored. This is
necessary so that Cable Asaeinbly and throttle
cable will not cross.
4. The Two Bead may need to be bent so that it
clears the throttle cable. (Figure 17) Also, the
4" Tie Strap can be used to hold the Two
Bead Connector to the sleeve of the throttle
cable. (Figure 17)
NOTE: After the Cable Assembly has been
Attached, manually move the throttle to assure
the Cable Assembly does not hang up on any
part of the vehi~le.
1, GM. Ford. and Chrvsler Throttle
Usin~THRQ1TLE CLIP WlTHCABLE
I. Some OM, Ford. and Cbrysler vehicles
have an attachment stud qn ~e throttle pulley .
2. Slide a Bead Chain Connector Cover over
the cruise cable, then attach the Bead Chain
Connector to the cable. Attac~ the Throttle
Clip with Cable to the Bead Chain Connector
And slide the Connector Cover over the Bead
Chain Connector. (Figure 18)
3. Slide the Throttle Clip over the throttle pulley
attachment stud. Push Throttle Clip onto the stud
until it snaps firmly onto the Stud.
Throttle Clip with C-able
FIGURE 18
Form #4313, Page 13