Naming/Renaming Setups; Editing Setups; Beeper - Competition Electronics Turbo35-GFX User Manual

Naming/Renaming Setups

A saved setup can be renamed in two steps.
First, navigate to the Rename line on page 1 of 1 of the set mode screen.
When the cursor is positioned on the Rename line, the first character position of the name
will begin to flash. In this line, the START button functions differently. It advances the
character position to the next character. To change the current character, rotate the rotary
dial. Proceed character by character until the full name appears in the display line.
The second step is this: advance to the "Save Rename To" line. Rotate the rotary dial to
select the setup to rename; then press START to rename the setup.

Editing Setups

To edit a setup,
• load the setup into T35-GFX active memory
• make changes to the desired settings in the active memory
• save the setup.
That's all there is to it.

Beeper

The T35-GFX contains an internal beeper that signals the end of cycle, as well as a
button press. The beeper action at the end of the cycle can be set to the OFF,
MOMENTARY, or CONTINUOUS modes.
Figure 22. Renaming a setup.
45