Lenovo ThinkStation P900 User Manual page 99

c. Remove the screw that is aligned with the M.2 slot.
Figure 24. Removing the screw that is aligned with the M.2 slot
• If you are replacing an M.2 solid-state drive, do the following:
a. Remove the flex adapter. See "Installing or replacing a flex adapter" on page 108.
b. Locate the M.2 solid-state drive that you want to replace.
c. Remove the screw that secures the M.2 solid-state drive. Then, gently pull the solid-state drive
out of the M.2 slot.
Figure 25. Removing the M.2 solid-state drive
7. To install a new M.2 solid-state drive, align the notch
key 2 in the M.2 slot. Then, insert the solid-state drive into an M.2 slot until it is secured tightly so that
the notch 3 is aligned with the corresponding screw hole in the flex adapter. Install the screw to
secure the solid-state drive.
Note: Ensure that the side with the circuit board is upward. Do not touch the circuit board of the
M.2 solid-state drive.
3
Figure 26. Installing the M.2 solid-state drive
8. Install the flex adapter into the flex adapter slot. See "Installing or replacing a flex adapter" on page 108.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
1 on the new M.2 solid-state drive with the slot
2
1
.
Chapter 9 Installing or replacing hardware
87