Mitsubishi Electric XD221U Service Manual page 31

Operating procedure
) Double-click [DLP Composer (TM) Lite .].
The following screen will appear.
Click the [Edit]
) Chose the Edit/Preferences from the menus of DLP
Composer (TM) ,and select the "USB Port" (DDP000/
DDP00) in the item of Communications.
Click here and
add a dot mark.
And setup the USB Device Identification under that, as follows
Vendor : 0x89
Product : 0xdfff
And next, click the [Configure], and set the numbers in the
window of USB Configuration as follows
0x89
0xdfff
input 0xdfff
Read Timeout : 0000mSec
Write Timeout : 0000mSec
Reset Delay : 000mSec
input 0x89
Further, in the place of Library, select the Browse and set
the pass of folder which contains the "Flash Device
Parameters .txt" for DDP0.
Click and set the pass
of holder
After set up is completed, push "O.K." in a DLP Composer
Preferences window . And then, close this program
temporary, and start again .
- 8 -
input 0000
input 0000
input 000
Click the Browse
Click the OK