Table of Contents
Advertisement
CLASSIFICATION
Einstufung
SUBJECT
Thema
CUSTOMER'S CODE
EvalPAN4570
For use of the P2 2mm contacts the black socket P2-X1 is the negative/ground contact
and the red socket P2-X2 is the positive terminal.
A linear regulator on the testboard regulates the input voltage down to the +5V DC board
supply. A second linear regulator regulates the +5V DC down to the module VCC supply
of 2,1/2,7/3,4Vdc.
5.2. D.C. POWER FROM A USB DEVICE:
In case no dedicated supply is available, DC supply can be taken from an USB
connection. The +5V DC from the USB feeds the linear regulator for the modules VCC
supply of 2,1/2,7/3,4Vdc (see Table 1).
Please note that communication via the USB connector is not possible.
Please take into account that when using the +5V DC feed to the 34-pin-headers in
combination with USB power supply the voltage is not +5V but unregulated 4.3 V DC due
to the voltage drop at a protection diode connected in series on the testboard.
Warning:
Do not overload the USB power source. Check for the current available from
your USB device in order to avoid malfunction of or damage to your USB power source.
5.3. POWER ON
Set SW7 to the position 1 = on. (With power from USB position 1 is off and position 2 is
on). D7 should be lit indicating that +5Vdc supply is available on the testboard. D8 should
be lit indicating that the regulated Vcc module supply is available.
The dc regulator output voltage is set with a jumper on JP3 or JP4 as follows:
jumper on
2-pin header
JP4 only (default)
no jumpers
JP3 only
European Technology Center
Panasonic Electronic Devices (EUROPE) GmbH
EvalBoard PAN4570
PANASONIC'S CODE
regulator output
voltage VCC
2,7 Vdc
3,4 Vdc
2,1 Vdc
No.
DS-Eval4570-2400
PAGE
Seite
DATE
Datum
remarks
typical for PAN4570
Maximum
for PAN4570
Minimum
for PAN4570
APPROVED
CHECKED
genehmigt
geprüft
REV.
C
7 of 20
06.11.2006
(Table 2)
DESIGNED
Erstellt
Advertisement
Table of Contents
