Table of Contents
Advertisement
CLASSIFICATION
Einstufung
SUBJECT
Thema
CUSTOMER'S CODE
EvalPAN4570
4. OPERATION OF THE TESTBOARD
If not already done please follow the basic setting up instructions as in
Check if the jumper plugs are set as indicated in Figure 2. The functions of the jumpers
are as follows:
jumper
ame
A
B
C
D
JP2
JP3
JP4
JP7
*
Position C is used as an example, position B or D could be used as well.
An amperemeter for measuring module current can be inserted instead of the jumper
** +5Vdc supply (independent on JP3 and JP4 settings) option is provided for application
demos. The +5Vdc supply is NOT used on PAN4570 carrierboard.
Check if the port switches S1 near to the COM2 connector for RS232 are all set to off
position except the selected UART as noted in Figure 2/Table 3.
5. POWER SUPPLY
5.1. D.C. POWER FROM A POWER SUPPLY
Set the power switch SW7 to the position 2 = off.
Connect a power supply with 7-9VDC to one of the power inputs (P1 or P2).
In case of P1 use a plug with 5,5mm diameter and the positive terminal at the centre
contact.
European Technology Center
Panasonic Electronic Devices (EUROPE) GmbH
EvalBoard PAN4570
PANASONIC'S CODE
function
Vcc for position A
Vcc for module at position B*
Vcc for module at position C*
Vcc for module at position D*
5Vdc feed to Slots A, B, C, D**
Vcc setting 2.1-2.7-3.4V;
see Table 2
Vcc setting 2.1-2.7-3.4V;
see Table 2
Vcc regulator output feed
to A, B, C, D
No.
DS-Eval4570-2400
PAGE
Seite
DATE
Datum
to set as in Figure 2
do not care
do not care
yes
do not care
no
no for
Vcc=2.7Vdc default
yes for
Vcc=2.7Vdc default
yes
APPROVED
CHECKED
genehmigt
geprüft
REV.
C
6 of 20
06.11.2006
Chapter 2
(Table 1)
DESIGNED
Erstellt
Advertisement
Table of Contents
