Installing The Filament - Tinkerine Studio Ditto Pro Quick Start Manual

INSTALLING THE FILAMENT

1 Extend the lament guide tube
from the retracted position.
Thread the lament through the guide tube and insert
4
it into the extruder. You'll need to push down on the
tensioner button to open up a gap.
If you are having trouble feeding the lament into the
hotend, pull the lament out and trim off the tip of the
lament with a pair of scissors.
Once the lament is inserted all the way down into
5
the hotend, insert the guide tube into the top of the
extruder cap.
Remove the lament spool from
2
the packaging and place it on
the spool holder.
Take the end of the lament
from the spool and insert it
3
into the guide tube.
PAGE 3