Beosound 2 Feedback; Switch Between Playback And Download; Change Mode; Docking Station Light Feedback - Bang & Olufsen Beosound 2 User Manual

Switch between playback and download: BeoSound 2 must be placed on
the docking station. Press GO to start playback, or press and hold GO for 2
seconds to connect to the computer – enabling you to download to
BeoSound 2. The docking station light changes colour accordingly.
Change mode: Switch between BeoPlayer and iTunes mode. BeoSound 2 is
in BeoPlayer mode per default. To change this setting, make sure that
BeoSound 2 is paused, and that the Earphones are connected.
Go to iTunes mode:
Press and hold ∧ and
Then press GO twice, without
letting go of the first two
buttons. Audible feedback
informs you that BeoSound 2 has
changed to iTunes mode.

BeoSound 2 feedback

Audible feedback: BeoSound 2 gives you audible feedback for example
when:
– Battery power is low (beep repeated every 30 seconds)
– Error occurs (beep repeated every 5 seconds)
– Firmware update is completed
– A memory card is formatted
Docking station light feedback: When BeoSound 2 is placed on the
docking station, the docking station lights up to indicate its current status:
Green... Track playback or pause, not connected to the computer.
Red... Download mode, connected to the computer.
Orange... Resetting – continuous orange light feedback indicates error.
Flashing light (red or green)... Battery charging.
Flashing red and green, followed by orange, then red... Updating Firmware.
Go to BeoPlayer mode:
Press and hold ∨ and
ss
.
Then press GO twice, without
letting go of the first two
buttons. Audible feedback
informs you that BeoSound 2 has
changed to BeoPlayer mode.
ss
.
11