Lexus RX350 Quick Manual page 84

■ Programming HomeLink
1
Press and release the HomeLink
®
HomeLink
3
Perform
gramming will not be able to be completed.
2
For U.S.A. owners
3
Programming an entry gate (for U.S.A. owners)/Programming a device in the Cana-
dian market
3
Press and release the remote control transmitter button at 2 second intervals, repeat-
edly, until the HomeLink
idly flashing (green) (rolling code) or continuously lit (green) (fixed code).
4
Test the HomeLink
ing the indicator light:
● Device with fixed code: If the indicator light is solid/continuous, programming has
been completed and your garage door or other device should operate when the
HomeLink
● Device with rolling code: If the indicator light flashes rapidly, your garage door
opener motor (or other device) is equipped with a rolling code. Complete the pro-
gramming process by firmly pressing and holding the programmed HomeLink
button for 2 seconds and then release the button.
● If the garage door or other device does not operate, proceed to "If your garage
door is of the rolling code type:".
RX350_QG_U_OM48E93U
®
®
button you want to program and check that the
indicator light flashes (orange).
1
within 60 seconds of , or the indicator light will stop flashing and pro-
®
indicator light changes from slowly flashing (orange) to rap-
®
operation by pressing the newly programmed button and observ-
®
button is pressed and released.
Point the remote control transmitter for the
device at the rear view mirror, 1 to 3 in. (25
to 75 mm) from the HomeLink
®
Keep the HomeLink indicator light in view
while programming.
Press and hold the handheld transmitter
button until the HomeLink
changes from slowly flashing orange to rap-
idly flashing green (rolling code) or continu-
ously lit green (fixed code), then release the
button.
®
buttons.
®
indicator light
®
84