Remote Control Preparation - Panasonic SC-ZT2 Operating Instructions Manual

Remote control
Standby/ON button (➜ page 16)
Test signal output (➜ pages 14, 21)
For using "WHISPER-MODE SURROUND"
For using "GAME" (➜ page 20)
For entering setup mode
(➜ pages 10, 15, 21 to 24)
For selecting or canceling
Dolby Virtual Speaker,
Dolby Pro Logic and SFC mode

Remote control preparation

Inserting the batteries
Press on the tab to open.
(R6/LR6, AA)
Insert so the poles (( and )) match those in the
remote control.
Use manganese batteries or alkaline batteries.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by
the manufacturer. Dispose of used batteries according to the manufacturer's instructions.
Using the remote control
Remote control signal sensor
Main unit
Approx. Approx.
30º
Transmission
window
(➜ page 20)
(➜ page 17)
Within 7 meters
(23 feet) at the front
30º
(The remote controlling
range varies according
to the angle)
Input mode and remote control code
buttons (➜ pages 16, 24)
For adjusting speaker output
(➜ pages 20, 21)
For adjusting the volume (➜ page 16)
Muting (➜ page 20)
For adjusting/activating settings
(➜ pages 10, 15, 21 to 24)
For returning to the previous menu
(➜ pages 10, 15, 21 to 24)
For remote control buttons used for speaker
setting, see pages 13 to 15.
• Do not mix old and new batteries.
• Do not use different types of batteries at the same time.
• Do not take apart or short circuit.
• Do not attempt to recharge alkaline or manganese batteries.
• Do not use batteries if the covering has been peeled off.
• Do not heat or expose to fl ame.
• Do not leave the batteries in an automobile exposed to direct
sunlight for a long period of time with doors and windows
closed.
Mishandling of batteries can cause electrolyte leakage which
can severely damage the remote control.
Remove the batteries if the remote control is not going to be
used for a long period of time. Store them in a cool, dark place.
Note
• Do not place an object between the signal sensor and
the remote control.
• Do not expose the signal sensor to direct sunlight or
strong light of a fl uorescent lamp.
• Keep the transmission window and the system's sensor
free from dust.
Note
7
VQT2R70