Table of Contents
Advertisement
| OMNIA VOCO® 8 - QUICK START SETUP GUIDE
12
Frequently Asked Questions
Read this first if you don't have time to read anything else in this guide
I'm getting a PSU error on the screen. What does that mean?
You probably didn't attach power to both power supply connections on the rear panel. Double-
check both AC power sources and connections.
But what if I don't want to connect both power cords?
Just do it. What have you got to lose (besides the pesky error message)? It isn't that we think a power
supply will fail; it's designed to improve overall reliability in plants with dual power feeds to the racks.
I've cleared the PSU error, but I'm still getting a "Control IP" or "Livewire/AES67
IP" error on the screen.
This generally indicates that an interface is set for DHCP and the cable is unplugged. Double-check
to ensure the interfaces are connected and that the IP address settings are correct. If you aren't
planning to use the "Control IP" or "Livewire/AES67" Ethernet interface, disable DHCP on that
interface to clear the error message.
I can't seem to find any controls besides preset selection and IP configuration—
Where is everything?
Most of the configuration is done through the Remote Gateway software and not from the front
panel. You'll need to configure the "Control IP" interface on the VOCO 8 and install the Remote
Gateway software on a PC. If you want to disconnect the unit from the network after initial
configuration, that's fine too—but it makes life a lot easier if you leave it on the network where a PC
running Remote Gateway can control it.
I connected to the unit through Remote Gateway but I'm still not finding any
controls. What gives?
There are three default login accounts on the VOCO 8; admin, studio, and live. The account that
grants access to the majority of the controls is "studio" . There is no default password for this account.
Admin will only allow basic configuration and rights management, and live essentially gives the
same level of access as the front panel.
User Name
admin
studio
live
Default Password
Function
admin
Administers user rights and global configuration
(no audio controls)
<none>
Allows full control over I/O and processing parameters
<none>
Similar to front panel controls; Changes sessions and presets,
limited control
Advertisement
Table of Contents
