Table of Contents
Advertisement
OMNIA VOCO® 8 - QUICK START SETUP GUIDE |
9
Adding the VOCO 8 to Remote Gateway
Once Remote Gateway is installed, you will need to add the VOCO 8 to the list of connections in
Remote Gateway. Scan for units on the network by clicking "Scan" .
Select the interface attached to the same network as the VOCO 8 and click "Run Scan" . You can also
add an IP address block not listed by clicking "Add Custom" . The default port for Remote Gateway
communications with the VOCO 8 is 3001 and should only be changed if necessary. When the scan
is complete, it should detect the VOCO 8. There will be multiple entries displayed for a single VOCO
8—this is due to the fact that there are multiple security levels and logins. You will need all three of
them added to Remote Gateway.
Advertisement
Table of Contents
