Buffalo AirStation WHR-300HP2 User Manual page 11

4
Turn on the AirStation and wait one minute.
5
If using a wired LAN, connect the AirStation LAN port and computer using a LAN cable.
If using a wireless LAN, connect the computer to the wireless LAN as described in chapter 4.
6
Once your computer has booted, the AirStation's LEDs should be lit as described below:
Power/Diag: Green LED on.
Wireless: Green LED on.
Router: Amber LED on.
For LED locations, refer to chapter 1.
Note: If the router LED is not lit, set the mode switch to "Router".
7
Launch a web browser. If the home screen is displayed, setup is complete.
If username and password fields are displayed, enter "admin" for the username and "password" for the password,
then click OK. Step through the wizard to complete setup.
You've completed the initial setup of your AirStation. Refer to chapter 3 for advanced settings.
11