STIEBEL ELTRON CNS 100 A Operation And Installation

STIEBEL ELTRON CNS 100 A Operation And Installation

Wall mounted convector heater
Hide thumbs Also See for CNS 100 A:

Advertisement

OPERATION AND INSTALLATION
WALL MOUNTED CONVECTOR HEATER
» CNS 100 A
» CNS 150 A
» CNS 200 A
» CNS 250 A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CNS 100 A and is the answer not in the manual?

Questions and answers

Summary of Contents for STIEBEL ELTRON CNS 100 A

  • Page 1 OPERATION AND INSTALLATION WALL MOUNTED CONVECTOR HEATER » CNS 100 A » CNS 150 A » CNS 200 A » CNS 250 A...
  • Page 2: General Information

    CONTENTS | OPERATION GENERAL INfORMATION OPERATION General information General information ��������������������������������������������2 Document information 1.1 Document information �������������������������������������������� 2 1.2 Key to symbols ������������������������������������������������������ 2 The chapter Operation is intended for users and heating contractors. Safety ������������������������������������������������������������3 2.1 Intended use ��������������������������������������������������������� 3 The chapter Installation is intended for heating contractors.
  • Page 3: Operation

    OPERATION SAfETY Safety information 1.2.3 Warning symbols/symbols Operate the appliance only when fully installed and with all safety Warning symbol Description equipment fitted. Injury WARNING Fire Electrocution Never operate this appliance ... — in rooms where the appliance is at risk of fire or explosion as a result of chemicals, dust, gases or Burns or scalding vapours.
  • Page 4: Appliance Description

    OPERATION APPLIANCE DESCRIPTION CE designation Frost protection The CE designation shows that the appliance meets all essential Turn the temperature selector as far to the right as possible. In » requirements according to the: this position, the temperature controller switches on the heating automatically if the room temperature drops to approx.
  • Page 5: Operation | Installation

    OPERATION | INSTALLATION CLEANING, CARE AND MAINTENANCE Safety Shutting down Move the switch on the right of the appliance to OFF. Only qualified contractors should carry out installation, » commissioning, maintenance and repair of the appliance. Pull the mains plug out of the socket. »...
  • Page 6: Installation

    INSTALLATION APPLIANCE hANDOvER 9.1.3 Dismounting the appliance Remove the safety cap from the locking bolt. » 1 Appliance 2 Safety cap 3 Locking bolt a a a Undo the locking bolt on the wall mounting bracket. » Lift the appliance up slightly and pull it forwards and away from »...
  • Page 7: Specification

    Minimum l.h. clearance Appliance Minimum front clearance Appliance Minimum rear clearance B01 Electrical cabel entry G05 Wall mounting bracket Hole spacing 11.2 Specification table CNS 100 A CNS 150 A CNS 200 A CNS 250 A 220734 220735 220736 220737 Connection output Setting range °C...
  • Page 8 Stiebel Eltron (Aust) Pty Ltd Who gives the warranty Address: 6 Prohasky Street, 1. The warranty is given by Stiebel Eltron (Aust) Pty Ltd (A.B.N. Port Melbourne, 82 066 271 083), 6 Prohasky Street, Port Melbourne, Victoria, 3207 Victoria, 3207 (“we”, “us”...
  • Page 9: Environment And Recycling

    18. The Stiebel Eltron warranty for the unit is in addition to any rights and remedies you may have under the Australian Consumer Law.
  • Page 10 NOTES |CNS A WWW.STIEBEL-ELTRON.COM...
  • Page 11 NOTES WWW.STIEBEL-ELTRON.COM CNS A|...
  • Page 12   Deutschland Verkauf Tel. 05531 702-110 | Fax 05531 702-95108 | info-center@stiebel-eltron.de STIEBEL ELTRON GmbH & Co. KG Kundendienst Tel. 05531 702-111 | Fax 05531 702-95890 | kundendienst@stiebel-eltron.de Dr.-Stiebel-Straße 33 | 37603 Holzminden Ersatzteilverkauf Tel. 05531 702-120 | Fax 05531 702-95335 | ersatzteile@stiebel-eltron.de Tel.

This manual is also suitable for:

Cns 150 aCns 200 aCns 250 a

Table of Contents