Technical Information - Panasonic TX-26LX60A Operating Instructions Manual

Technical Information

When you receive the stereo / bilingual sound system, sound output modes can be selected by pressing
the Stereo / Bilingual Sound Selection button.
Audio Signal
Mode Indicator
NICAM .......Used in New Zealand, Singapore, Hong Kong etc.
Type of broadcast
Mode Indicator
A2 (German) .......Used in Australia, Malaysia etc.
Type of broadcast
Mode Indicator
Note
•
If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switching
occurs, it is recommended you switch from STEREO to MONO.
•
Even when the contents of the receiving signal undergo changes, selection mode is kept intact.
•
When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position, using
the stereo / bilingual sound selection button.
•
DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.
∗ Mark: Applicable input signal for Component (Y, P
Signal name
480i(525)/60Hz
480p(525)/60Hz
576i(625)/50Hz
576p(625)/50Hz
720p(750)/60Hz
720p(750)/50Hz
1080i(1125)/60Hz
1080i(1125)/50Hz
•
Note
•
HDMI connections to some Panasonic equipments allow you to enjoy the easy playback or home theatre.
•
Setup the equipment to enable this function. Read the manual of the equipment.
•
Switch the TV unit on again with the equipment on when connection or setup is changed.
•
This function may not work normally depending on the equipment condition.
•
The equipment can be operated by TV's remote control with this function on even if TV is in Standby mode.
•
Image or sound may not be available for the fi rst few seconds when the playback starts.
•
Image or sound may not be available for the fi rst few seconds when Input mode is switched.
26
Stereo / Bilingual Sound Selection
STEREO
Regular broadcast
(Standard Audio)
No Indicator
Regular broadcast
(Standard Audio)
No Indicator
Input signal that can be displayed
Horizontal frequency (kHz)
Signals other than above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.
MAIN
I
I
Regular + NICAM MONO
(MAIN )
I
I
BILINGUAL or DUAL MONO:
MAIN / SUB
I II
I II
/C , P /C ) and HDMI
B B R R
Vertical frequency (Hz)
15.73
31.47
15.63
31.25
45.00
37.50
33.75
28.13
Control with HDMI
SUB
II
II
NICAM DUAL MONO
I
NICAM STEREO
(MAIN
STEREO
Component
59.94
59.94
50.00
50.00
60.00
50.00
60.00
50.00
MONO
/ SUB )
I II
II
I
HDMI
∗ ∗
∗ ∗
∗ ∗
∗ ∗
∗ ∗
∗ ∗
∗ ∗
∗ ∗